Terk-technologies XMDGM100 Manual de usuario Pagina 1

SMART DIGITAL ADAPTERInstallation GuideXMDGM100Smart Digital Adapter for GM Car Radios

9Upon completion of your installation your XM tuner will need to beactivated. Tune the XM tuner to the Preview Channel, channel 1 and followinstructi

Limited WarrantyTERK is a registered trademark. The TERK logo is a trademark of the TERK Technologies Corp.Limited Warranty TERK Technologies Corp. (T

1Smart Digital AdapterUse in conjunction with an XM universal tuner box, the XMDGM100 Smart Digital Adapter allows you to adapt an existing GM satelli

2Introduction:: (continued)Part 1:: XM Direct – Universal Tuner BoxA1 :: Micro antenna with single outputA2 :: Universal XM Tuner Box Part 2:: XM Dire

InstallationThe following step-by-step instructions illustrate in detail twotypical GM installations. The images on the left are for a typical SUVins

4STEP 3UNPLUG EXISTING CONNECTORS AND ANTENNA CABLE AND REMOVE RADIO. INSTALL LARGE AND SMALL CONNECTORS (REMOVED FROM RADIO) INTOHARNESS (W1) SUPPLIE

5InstallationSTEP 5INSTALL RED AND WHITE RCA AUDIO CABLES (W2)AND 8 PIN MINI DIN CABLE (W3) INTO OPPOSITE SIDE OF DIRECT CONNECT INTERFACE BOX.STEP 6

6InstallationSTEP 7LOCATE AND MOUNT THE ADAPTER BOX (A3) IN SUITABLE LOCATIONTHAT WILL NOT INTERFERE WITH THE RADIO AND WILL NOT VIBRATE ORRATTLE AFT

7InstallationSTEP 9CAREFULLY LOCATE THE RADIO BACK INTO POSITION. MAKE SURE THAT THE HARNESS DOES NOT BLOCK THE RADIO UNIT OR GET CRIMPED BY THE RADI

8InstallationSTEP 12AT THIS POINT OF THE INSTALLATION THE RED AND WHITE RCA CABLE,THE 8 PIN MINI DIN CABLE AND THE XM ANTENNA CABLE SHOULD ALLBE ROUTE